Mac mini Late 2014 SSD Replacement
By Sam Goldheart • Difficulty: Moderate
Introduction

Use this guide to replace the SSD stick in an SSD only, or Fusion Drive model of the Mac mini Late 2014.

Step 1
  • The bottom cover is clipped onto three screw posts.
  • Pry near, but not right on the screw posts.
Step 2
  • Use the plastic opening tool to pry the bottom cover up off of the Mac mini.
Step 3
  • Lift and remove the bottom cover.
Step 4
  • Remove the following TR6 screws from the antenna plate:
  • Three 4.1 mm screws
  • Three 1.9 mm screws
Step 5
  • Do not completely remove the antenna plate; it is still connected to the Mac mini by an antenna cable.
  • With the I/O ports facing you, flip the antenna plate to the right to allow access to the antenna cable connector.
Step 6
  • Remove the single 3.4 mm T6 screw and washer from the antenna cable.
  • Be careful not to lose the washer when removing the screw.
Step 7
  • Use the point of a spudger to lift the antenna connector straight up off its socket on the airport card.
Step 8
  • Carefully pull the antenna cable out from the gap between the power supply and case.
Step 9
  • Remove the antenna plate from the Mac mini.
Step 10
  • Remove the 5 mm T5 screw securing the SSD.
Step 11
  • Lift the free end of the SSD up slightly and pull it out of its socket.
Step 12
  • Carefully lift the SSD out of the case without scratching or touching the gold contacts.
Conclusion

To reassemble your device, follow these instructions in reverse order.